Band saw - Powermatic

Step 1: Perform pre-use inspection and check work area

Hazards

• Bodily Injury
• Pingching hazards

Controls

• Complete hands-on band saw training prior to use
• Make sure work area is clean and well lit
• Red tag any equipment which does not pass inspection
• Check the condition of blade and guards, and replace those obstructed, or dull blades or guards.
• Check the blade type, replace it if it is not for the material
• Tighten blade if loose
• Always Lockout/Tagout machine when changing/tightening blades

Step 2: Operating a stationary band saw

Hazards

• Lacerations
• Amputations
• Flying sawdust

Controls

• Don PPE, including work shoes with non-slip soles, a dust mask and safety glasses
• Use clamp or vice to secure small of material
• Keep guards in place, do not bypass
• Keep loose clothing, hair and jewelry away from moving parts
• Keep fingers and hands away from pinch points
• Always allow the motor to come to full speed before cutting
• Never start the equipment when the blade is in contact with a work piece
• Ensure work piece is flat against work table, never attempt to cut work at elevated heights; this will cause the work piece to move down with the blade and can cause injury
• Never cut more than one piece at a time
• Blade will coast when it is turned off
• Always Lockout/Tagout machine when changing blades or removing jammed pieces